Hotend Heating Assembly - A1 Series
₹3,000.00
Taxes Included
Overview
The Hotend Heating Assembly is specially designed to support the quick swap design of the hotend. A quick clamping mechanism is used to secure the heater block and heating base, enabling easy separation of the thermal and electronic components of the hotend.
The hotend heating assembly can heat the hotend up to 300℃ and measure the real-time temperature of the hotend with the included thermistor.
In the Box
1. Hotend Heating Assembly * 1
2. BT3-10 Screws * 3
Compatibility
A1 Series
Quantity
Verify the functionality of the A1 hotend heating assembly
To ensure everything runs smoothly, set the hot end temperature to 100°C. If successful, the screen will show the temperature.
Calibration step after the operation
We recommend conducting a full calibration of the printer after this operation.
Additionally, it's strongly advised to wash the PEI textured plate before use, as it may have been contaminated during this process.
Potential problems and solutions
If you encounter problems during the installation of a new Hotend Heating Assembly, please check the potential problems and solutions listed below:
The hotend temperature is 0℃
Check the Hotend Heating Assembly connector and confirm it is correctly inserted, as shown in Re-connect the cablesIt is important to carefully align the connector pins to the TH Board.If the issue persists, the thermistor wires might have been damaged (white wires)
The hotend cannot be heated
Check the Hotend Heating Assembly connector and confirm it is correctly inserted, as shown in Re-connect the cableIt is important to carefully align the connector pins to the TH Board.If the issue persists, the heater wires might have been damaged (Translucent wires)
